A front-loading washer is a genuinely different machine. Its drum sits horizontally on a sealed bearing that carries the entire weight of a wet load through a spin cycle running at over a thousand revolutions a minute. Its door is closed by a deep rubber boot that holds a little water after every wash. It traps debris in a drain pump filter behind a panel most owners have never opened. It needs HE detergent, and punishes you with suds and error codes when it does not get it. None of those parts exist on a top-loader — which is why a general appliance listing is not much use when yours is the machine that is broken. Every technician we connect you with works on front-loaders as a matter of routine.
## Stat band Nationwide Coverage · 50 States · Front-Load Only · Free Quotes
Musty smell or a torn, moldy door boot — the most common front-load complaint there is.
Read more →Water at the door or under the machine. Where it appears tells you what failed.
Read more →
| Job type | Typical range |
|---|---|
| Diagnostic call-out | $75 – $130 (often credited against the repair) |
| Door boot seal replacement | $120 – $500 |
| Drum bearing replacement | $150 – $250 |
| Drain pump / filter work | $100 – $250 |
| Control board | $200 – $500 |
These are typical ranges reported across the network, not a fixed price list. Your local technician quotes a flat price before any work starts. Front-load repairs generally run higher than the equivalent top-loader job, because more of the machine has to come apart to reach the part.
Tell us what the machine is doing, the brand, and roughly where you are.
A local technician gives you a flat price before any work starts.
Depends on your local partner's schedule — we'll give you a straight answer.
They're an independent business. If it's not right, we'll send another partner at no extra cost.
Not a general appliance list with front-loaders mentioned somewhere.
Checked before a technician takes a referral, re-checked on a rolling basis.
The quote is the price. No fuel surcharge, no padded call-out fee.
Partners stay only if they keep showing up and quoting straight.
Wherever you are — and the person at your door works in your area.
Moving, managing a rental, or just tired of searching.
Tell us the brand and what it is doing. Flat quote before anything starts.
Usually, yes. Most front-load repairs run a few hundred dollars against $800 to $1,500 or more for a comparable replacement machine. The exception is a machine that is already eight or ten years old and needs a major repair — a failed bearing or a corroded spider arm — where the cost starts to approach a new unit. A good technician will tell you which situation you are in rather than pushing the repair either way.
Almost always the door boot seal. That rubber fold holds water after every cycle, and detergent and fabric-softener residue build up behind it until mold takes hold. Cleaning the boot, the dispenser drawer and the drain pump filter clears most cases. Leaving the door ajar between loads and switching to HE detergent in the right dose prevents it coming back.
Most repairs land between $150 and $450. A diagnostic call-out typically runs $75 to $130, often credited against the repair. Door seal replacement generally falls between $120 and $500 depending on brand, and drum bearings run a few hundred dollars. Front-load repairs do tend to cost more than the equivalent top-loader job, because more of the machine has to come apart.