Nobody plans for the washer to fail. It happens on a Sunday with a full drum and a week of laundry behind it. Our network covers Lebanon and the surrounding Grafton County, and one call gets you an independent technician who works on front-loading machines rather than whoever is nearest. You will know the price before anyone picks up a screwdriver.
Technicians in our network cover Lebanon itself and the surrounding communities, including Claremont (17.7 miles), Franklin (31.8 miles), Rutland, VT (36.3 miles), Laconia (38.8 miles), Concord (44.5 miles) and Keene (47.2 miles). If your town is not named here, call anyway and tell us where you are — coverage usually reaches further than the list.
Granite bedrock gives New Hampshire some of the softest water in the country, so scale is close to a non-issue in Lebanon. Winter is what matters: a front-loader holds standing water in its drain pump trap by design, putting that trap and the supply hoses at real risk in an unheated basement or attached garage — where much of the state's older housing puts the laundry.
A front-loader spins its drum horizontally at high speed, and the whole weight of a wet load rides on a sealed bearing behind the drum. When that bearing starts to fail it announces itself — a low roar or grinding that gets dramatically louder as the spin speeds up, often with play in the drum if you rock it by hand. This is the repair worth catching early. A bearing job typically runs a few hundred dollars, but a bearing left to disintegrate will destroy the drum and outer tub with it, turning a moderate repair into a bill approaching the cost of a new machine. If your washer in Lebanon has started roaring, get it looked at now rather than next month.
Maytag front-loaders share much of their engineering with Whirlpool, which means good parts availability and a lot of technicians who know them well. Bearing noise on higher-mileage machines and door boot wear are the faults that come up most. Our network's technicians service Maytag front-load washers as a matter of routine.
Tell us what the machine is doing, the brand, and roughly where you are.
A local technician gives you a flat price before any work starts.
Depends on your local partner's schedule — we'll give you a straight answer.
They're an independent business. If it's not right, we'll send another partner at no extra cost.
A flat price before any work starts. You pay the local pro directly.
In many areas a technician can be out the same day or the next, but it genuinely depends on your local partner's schedule and how busy the market is that week. Call and tell us where you are and we will give you a straight answer rather than a guess.
Usually, yes. Most front-load repairs run a few hundred dollars against $800 to $1,500 or more for a comparable replacement machine. The exception is a machine that is already eight or ten years old and needs a major repair — a failed bearing or a corroded spider arm — where the cost starts to approach a new unit. A good technician will tell you which situation you are in rather than pushing the repair either way.
Typically $75 to $130, depending on the market. Most technicians in our network credit that fee against the cost of the repair if you go ahead with the work. You will be told the diagnostic fee before anyone is dispatched — there should be no surprise on the doorstep.